Forum des NAS

Gaudi a écrit : ↑26 oct. 2020 15:24

oyasama a écrit :Hello, does not start after upgrading QTS firmware to 4.5.1

Best regards

Try to start the app from a SSH session and check if any error messages appear?

Can you please tell me what the command would be to run unifi by console? I don't usually fret much with putty in the qnap, I'm sorry. Thank you. Best regards

oyasama a écrit : ↑26 oct. 2020 17:07

Gaudi a écrit : ↑26 oct. 2020 15:24

oyasama a écrit :Hello, does not start after upgrading QTS firmware to 4.5.1

Best regards

Try to start the app from a SSH session and check if any error messages appear?

Can you please tell me what the command would be to run unifi by console? I don't usually fret much with putty in the qnap, I'm sorry. Thank you. Best regards

Okay, now I see that with firm 4.5.1 there is an app manager around the console, easier, I'll see if I get any errors from the console. Thanks again.

oyasama a écrit : ↑26 oct. 2020 17:14

oyasama a écrit : ↑26 oct. 2020 17:07

Gaudi a écrit : ↑26 oct. 2020 15:24
Try to start the app from a SSH session and check if any error messages appear?

Can you please tell me what the command would be to run unifi by console? I don't usually fret much with putty in the qnap, I'm sorry. Thank you. Best regards

Okay, now I see that with firm 4.5.1 there is an app manager around the console, easier, I'll see if I get any errors from the console. Thanks again.

Well, it looks like with the new console app manager in 4.5.1, I've been able to run unifi and it works. The problem may not start with QTS boot after restarting. At least I had restarted the nas 3 times without success. Thanks anyway.

impossible de DL ce package

Bizarre j'utilise ce package depuis très longtemps et aucun pb. Je télécharge le package en allant sur le site : https://www.qnapclub.eu/fr/ puis je fait une installation manuel .
Pour les mise à jour il suffit de télécharger la nouvelle version et de l'installer , les réglages du contrôleur ne sont pas perdu .