Contenu récent par gmqnap

Merci beaucoup! Je parle un petit-peu francais, mais je me ne rappelle pas comment je le dois ecrire... :-) A bientot!

Hi all! It's a long time i use QNAP NASes, and they are a really good solution for everything you need at home and at work. Recently they changed their road map, radically. They forbide to use a third party PCI-E controller for nvme ssds, allowed for caching only. But if you installed the...

No signs under dmesg (neither negative nor positive), but it is in the list of loaded modules (lsmod). i'll try to use it. Thanks!

So i'll take a try! You have been incredibly kind and gentle, unbeatable. Thanks a lot, GM

Your QPKG directory exists, and i think everything has been installed. But the installation do not finish correctly and no icon appears on the visual interface. Moreover if i connect e HL-340 usb to serial interface i think the module is not running correctly, because no serial port appears...

Of course. (Thanks for your prompt replies)

Consolle output (at the end) [...] Firmware check is fine. Link service start/stop script: USBSerialdrivers.sh Set QPKG information in /etc/config/qpkg.conf And nothing more. Sadly it stucks here, do you want to take a look to everything after the sh command? i took a look to the qpkg.conf...

Very interested to this package, absolutely necessary for Octoprint, sadly installation stucks to 80%. I did a lot of tries. My NAS is TVS-682 with latest firmware 4.4.1.1216 (14-02-2020). I think it doesn't depends on memory and processor and free disk space (i7 6700T, 64Gb RAM, 12Tb of free...

Ok, thanks a lot! I hope i will find config file easily... :-P GM

I'm sorry, not the Transmission Web Interface, but the Admin page... Where i can change ports or folder where to save files, username and password and so on. Thanks!

I'm sorry i tried the latest version (2.92.1 x64) and it runs fine... But i cannot connect to the Admin Center interface anymore. I don't know the right port or it doesn't exist anymore? Thanks in advance, GM